using	Board::LoggerDevice = modm::IODeviceWrapper< stlink::Uart, modm::IOBuffer::BlockIfFull >

void	Board::initialize ()

void	Board::initializeUsbFs (uint8_t priority=3)

using	Board::usb::Vbus = GpioA9

using	Board::usb::Id = GpioA10

using	Board::usb::Dm = GpioA11

using	Board::usb::Dp = GpioA12

using	Board::usb::Overcurrent = GpioInputG7

using	Board::usb::Power = GpioOutputG6

using	Board::usb::Device = UsbHs

using	Board::stlink::Tx = GpioOutputD8

using	Board::stlink::Rx = GpioInputD9

using	Board::stlink::Uart = BufferedUart< UsartHal3, UartTxBuffer< 2048 > >

Detailed Description

lbuild module: modm:board:nucleo-h723zg

TinyUSB

To use the USB port, you must configure TinyUSB to use the HS port in FS mode: